Kunci Jawaban CCNA2 Chapter 2 Exam Answer 2015 v5 03
CCNA2 Chapter 2 Exam Answer 2015 v5.03
1. Which interface is the default location that would contain the IP address used to manage a 24-port Ethernet switch?
· VLAN 1
· Fa0/0
· Fa0/1
· interface connected to the default gateway
· VLAN 99
2. A production switch is reloaded and finishes with a Switch> prompt. What two facts can be determined? (Choose two.)
· POST occurred normally.
· The boot process was interrupted.
· There is not enough RAM or flash on this router.
· A full version of the Cisco IOS was located and loaded.
· The switch did not locate the Cisco IOS in flash, so it defaulted to ROM.
3. Which two statements are true about using full-duplex Fast Ethernet? (Choose two.)
· Performance is improved with bidirectional data flow.
· Latency is reduced because the NIC processes frames faster.
· Nodes operate in full-duplex with unidirectional data flow.
· Performance is improved because the NIC is able to detect collisions.
· Full-duplex Fast Ethernet offers 100 percent efficiency in both directions.
4. Which statement describes the port speed LED on the Cisco Catalyst 2960 switch?
· If the LED is green, the port is operating at 100 Mb/s.
· If the LED is off, the port is not operating.
· If the LED is blinking green, the port is operating at 10 Mb/s.
· If the LED is amber, the port is operating at 1000 Mb/s.
5. What is a function of the switch boot loader?
· to speed up the boot process
· to provide security for the vulnerable state when the switch is booting
· to control how much RAM is available to the switch during the boot process
· to provide an environment to operate in when the switch operating system cannot be found
6. In which situation would a technician use the show interfaces switch command?
· to determine if remote access is enabled
· when packets are being dropped from a particular directly attached host
· when an end device can reach local devices, but not remote devices
· to determine the MAC address of a directly attached network device on a particular interface
7. Refer to the exhibit. A network technician is troubleshooting connectivity issues in an Ethernet network with the command show interfaces fastEthernet 0/0. What conclusion can be drawn based on the partial output in the exhibit?
CCNA2 Chapter 2 v5.03 004
· All hosts on this network communicate in full-duplex mode.
· Some workstations might use an incorrect cabling type to connect to the network.
· There are collisions in the network that cause frames to occur that are less than 64 bytes in length.
· A malfunctioning NIC can cause frames to be transmitted that are longer than the allowed maximum length.
8. Refer to the exhibit. The network administrator wants to configure Switch1 to allow SSH connections and prohibit Telnet connections. How should the network administrator change the displayed configuration to satisfy the requirement?
CCNA2 Chapter 2 v5.03 001
